Other Problems - Miele PT 7136 Plus Operating And Installation Instruction

Problem solving guide

Other problems

Problem
The drying
process goes on
too long or even
switches off.
The laundry is
not sufficiently
dry.
32
Possible cause
In some circumstances the following message also appears:
Clean out airways.
Please check all possible causes, and open and shut the
dryer door.
Ventilation to the dryer is
insufficient (e.g because it
is installed in a room which
is too small).
The fluff filter is blocked.
The vent ducting or the
ventilation outlet is
blocked.
The laundry has not been
spun sufficiently.
The tumble dryer has been
overloaded.
Metallic components, e.g.
zips, have prevented the
dryer from registering the
correct moisture level in
the laundry.
The load consisted of
different fabrics.
Remedy
Open a door or window while
the machine is in operation for
increased air flow.
Remove any fluff.
– Check all parts of the vent
ducting system on a regular
basis (e.g. wall pipe, external
grille, bends in the ducting
etc.) and make sure they are
all free of any hindrance.
– Remove any fluff.
Make sure that your laundry is
thoroughly spun at the
appropriate spin speed.
Do not exceed the maximum
load for the programme
selected.
– Open zips next time.
If the problem occurs again, dry
garments with long zips using
the Warm air programme.
– Finish drying using the Warm
air programme.
– Select a different programme
next time (see Programme
chart).