Miele PT 7136 Plus Operating And Installation Instruction page 31

Problem
The following
appears at the
end of the
programme:
Clean the filter
Clean out
airways
Programme finish
time changed
Possible cause
The dryer is reminding
you that the filter needs
cleaning.
You can adjust the
setting which controls
when or if the message
Clean the filter appears.
The dryer is not working
efficiently or
economically.
Possible cause: The fluff
filter is clogged with fluff
or with detergent
residues.
The vent ducting may be
very long, which does
not constitute a fault.
This is not a fault.
Problem solving guide
Remedy
– Remove and clean the filter.
To delete the fault message:
– Confirm with OK.
– See "Settings menu J, Cleaning
the filter".
– Check all possible causes given
below under "The drying
process goes on too long or
even switches off."
To delete the fault message:
– Confirm with OK.
If very long ducting is used, then
programme times will be longer
and energy consumption higher.
You can adjust the setting which
controls when or if the message
Clean out airways appears.
– See "Settings menu J, Clean out
airways".
In the period between selecting
Delay start and the programme
starting, the settings were
changed or there was a power
cut.
31