Filling The Engine With Oil; Charging The Battery; Product Overview; Installing The Fuse - Toro Super Recycler 20062 Operator's Manual

2. Filling the Engine with Oil

Your mower does not come with oil in the engine.
1. Remove the dipstick (Figure 7).
Figure 7
2. Slowly pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 7). Do not
overfill. (Max. fill: 20 oz. (0.59 l), type: SAE 30W
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
3. Install the dipstick securely.
Important: Change the engine oil after the first 5
operating hours; change it yearly thereafter. Refer
to Changing the Engine Oil.

3. Installing the Fuse

Your mower comes with a 40-amp fuse that protects the
electric starter.
Important: You cannot start the mower with the
electric starter or charge the battery unless you install
the fuse.
1. Unclip both ends of the battery cover and remove it
(Figure 8).
Figure 8
2. Install the fuse in the fuse holder (Figure 9).
Figure 9
Note: Your mower comes with a fuse in the your
owner's packet and another fuse in the battery box.
3. Install the battery cover.

4. Charging the Battery

Refer to Charging the Battery in the Maintenance section.

Product Overview

Figure 10
1. Upper handle
2. Handle knob (4)
3. Battery (not shown)
4. Fuel tank cap
5. Side discharge
6. Air lter
7. Primer
Figure 11
1. Grass bag
2. Side discharge chute
6
8. Spark plug
9. Cutting height lever (4)
10. Oil ll/Dipstick
11. Recoil start handle
12. Electric starter
13. Blade control bar
3. Battery charger
4. Rear discharge plug (installed)