Using The Self-Propel Drive; Bagging The Clippings; Stopping The Engine; Recycling The Clippings - Toro Super Recycler 20062 Operator's Manual

Figure 21
4. If the mower does not start in 1 or 2 pulls (or 5 seconds
using the electric starter), press the primer button 1 or 2
times and try starting it again.
Note: If the mower still does not start, contact an
Authorized Service Dealer.

Using the Self-propel Drive

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your sides,
and the mower will automatically keep pace with you
(Figure 22).
Figure 22

Stopping the Engine

Release the blade control bar (Figure 23).
Important: When you release the blade control bar,
the blade should stop within 3 seconds. If it does not
stop properly, stop using your mower immediately and
contact an Authorized Service Dealer.
Figure 23

Recycling the Clippings

Your mower comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the mower, remove it (refer to
Removing the Grass Bag) before recycling the clippings. If
the side discharge chute is on the mower, remove it and
lock the side discharge door (refer to Removing the Side
Discharge Chute) before recycling the clippings.
Important: Ensure that the rear discharge plug is in
place before you recycle the clippings (Figure 24).
Figure 24

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
If the side discharge chute is on the mower, remove it and
lock the side discharge door (refer to Removing the Side
Discharge Chute) before bagging the clippings.
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
9