Replacing The Air Filter; Changing The Engine Oil - Toro Super Recycler 20062 Operator's Manual

Replacing the Air Filter

Replace the air filter yearly; replace it more frequently in
dusty operating conditions.
1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance.
2. Use a screw driver to open the air filter cover (Figure
34).
Figure 34
3. Replace the air filter.
4. Install the cover (Figure 35).
Figure 35

Changing the Engine Oil

Change the engine oil after the first 5 operating hours;
change it yearly thereafter.
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance.
2. Remove the dipstick (Figure 36).
Figure 36
3. Tip the mower onto its side, with the air filter up, to
drain the used oil out through the oil fill tube (Figure
37).
Figure 37
4. Slowly pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 38). Do
not overfill. (Max. fill: 20 oz. (0.59 l), type: SAE 30W
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
Figure 38
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
13