3
Filling the Engine with Oil
No Parts Required
Procedure
Important: Your machine does not come with oil in
the engine. Before starting the engine, fill the engine
with oil.
Engine oil capacity: 0.47 L (16 oz)
Oil viscosity: SAE 30 or SAE 10W-30 detergent oil
API service classification: SJ or higher
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Dipstick
2. Add
3. Carefully pour about 3/4 of the engine capacity of oil
into the oil-fill tube.
4. Wipe the dipstick clean with a clean cloth.
5. Insert the dipstick into the oil-fill tube, then remove
the dipstick.
6. Read the oil level on the dipstick
•
If the oil level is below the Add mark on the
dipstick, carefully pour a small amount of oil into
the oil-fill tube, wait 3 minutes, and repeat steps
through
5
until the oil level is at the Full mark on
the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level is at
(Figure
8).
Figure 8
3. Full
(Figure
8).
the Full mark on the dipstick; refer to
the Engine Oil (page
Important: If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
7. Install the dipstick securely.
4
Assembling the Grass Bag
No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
1
g187518
1. Handle
2. Frame
Note: Do not slip the bag over the handle
2. Hook the bottom channel of the bag onto the bottom
of the frame
3
6
16).
3
2
Figure 9
3. Grass bag
(Figure
10).
Changing
Figure
9.
g027120
g027120
(Figure
9).