Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
Most console problems are the result of low batter-
ies. To replace the batteries, see assembly step 10 on
page 9.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must remove the left
pedal, the resistance knob cover, and the left shield.
Using an adjustable wrench, turn the left pedal clock-
wise and remove it.
Press the tabs on the
sides of the resistance
control and pull the
Resistance Knob (14)
upward off the resis-
tance control.
See the EXPLODED DRAWING on page 19.
Remove the two M4 x 12mm Screws (43) and the
three M4 x 16mm Screws (27) from the Left Shield (9).
Then, remove the Left Shield.
14
Tab
Tab
Locate the Reed Switch (33). Rotate the Pulley (24)
until a Magnet (32) is aligned with the Reed Switch.
Loosen, but do not remove, the indicated M4 x 15mm
Screw (41). Slide the Reed Switch slightly toward or
away from the Magnet.
24
Then, retighten the M4 x 15mm Screw (41). Turn the
Pulley (24) for a moment. Repeat these actions until
the console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the left shield, the resistance knob, and the left pedal.
14
32
33
41
Advertisement
Table of Contents
