Maintenance And Troubleshooting - Weslo pursuit 360R WLEX1476.0 User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. To replace the batteries, see
assembly step 9 on page 9.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must first remove the
left pedal and the left shield. Using an adjustable
wrench, turn the left pedal clockwise and remove it.
Next, remove all the screws from the left and right
shields; there are two sizes of screws in the
shields–note which size of screw you remove from
each hole. Then, gently pull the left shield away from
the frame.
Turn the resistance knob to the lowest setting. Then,
locate the Reed Switch (43).
43
38
47
Turn the Crank (21) until the Magnet (38) is aligned
with the Reed Switch (43). Loosen, but do not remove,
the M4 x 15mm Self-tapping Screw (47). Slide the
Reed Switch slightly closer to or away from the
Magnet, and then retighten the Screw. Turn the Crank
for a moment.
21
Repeat until the console displays correct feedback.
When the Reed Switch is correctly adjusted, reattach
the left shield and the left pedal.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is at the highest level, the
drive belt may need to be adjusted.
To adjust the drive belt, you must first remove the right
pedal and the right shield. Using an adjustable
wrench, turn the right pedal counterclockwise and
remove it. Next, remove all the screws from the left
and right shields; there are two sizes of screws in
the shields–note which size of screw you remove
from each hole. Then, gently pull the right shield
away from the frame.
Loosen the Flywheel Axle (39). Next, tighten the M6
Locknuts (63), one on each side of the Flywheel (37),
until the Drive Belt (35) is tight. Then, tighten the
Flywheel Axle and reattach the right shield and the
right pedal.
35
37
63
39
14