Table of Contents
Advertisement
9. Have a second person hold the Right Handrail
(105) near the Right Upright (79). Remove the
tie from the bracket on the Right Handrail.
Insert the Upright Wire (86) into the bottom of
the Right Handrail (105) and pull it out of the
hole in the top of the Right Handrail.
Attach the Right Handrail (105) to the Right
Upright (79) with three 5/16" x 3/4" Bolts (4) and
three 5/16" Star Washers (9); do not fully
tighten the Bolts yet. Be careful not to pinch
the Upright Wire (86).
10. Have a second person hold the console assem-
bly near the Right Upright (79). Connect the
Upright Wire (86) to the console wire. See the
inset drawing. The connectors should slide
together easily and snap into place. If they do
not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN YOU TURN ON THE POWER.
Then, remove the wire tie from the Upright Wire.
Insert the connectors and the excess wire into
the Right Handrail (105).
Set the console assembly on the Right Handrail
(105) and the Left Handrail (not shown). Be
careful not to pinch the wires.
9
Hole
Tie
4
9
4
10
Console
Assembly
105
86
79
10
86
105
79
Console
Wire
Console
Wire
Wire Tie
86
Advertisement
Table of Contents
