Primera AP360e Quick Start Manual page 6

6. Now position the stock to correspond with the general area where it will be applied to
7. Pull the loose end of the label stock forward and then push it into the Feed Area from the
Figure 2-5.
8. Pull approximately 12 inches of label stock out beyond the Peel Edge. (Figure 2-6.)
Figure 2-6.
Peel Edge
6 AP360e/362e Label Applicator
the container.
back of the printer. The labels will come out just underneath the Peel Edge. (Figure 2-5.)
Tip! See Section 5 for
a Label Path diagram.
Label Guides