Projecting; Selecting The Image; How To Adjust The State Of The Image - Panasonic PT-TW230E Operating Instructions Manual

Projecting

Check the connections of the peripheral devices and connection of the power cord (
Æ
power ( page 25) to start the projector. Select the image and adjust the state of the image.

Selecting the image

Select an input signal.
The image selected with the <COMPUTER 1>,
<COMPUTER 2>, <HDMI>, <VIDEO>, <S-VIDEO>,
or <COMPONENT> button is projected (
Attention
Images may not be projected properly depending on the
z
connected device and DVD, video tape, etc. to be played.
Select a system format that is suitable for the input signal
in [Component] or [RGB] in the [Input] menu (
Check the aspect ratio of the screen and the image and
z
select the optimum aspect ratio under the [Screen] menu
( Æ page 44).
How to adjust the state of the
image
1 ) Adjust the projection angle.
For details, see "Adjusting front adjustable feet".
z
( page 21)
Æ
2 ) Adjust the focus.
Turn [Focus lever] to adjust the image.
Focus Lever
Note
It is recommended that the images are projected
z
continuously for at least 30 minutes before the focus is
adjusted.
If keystone distortion occurs, see "KEYSTONE"
z
Æ
( page 45).
28
- ENGLISH
Æ page 29).
Æ page 35).
Æ
page 23) and switch on the