About Your Projector; Remote Control - Panasonic PT-TW230E Operating Instructions Manual

About Your Projector

Remote control

(17)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(1) <AUTO SETUP> Button
Execute the setting of Auto setup in the setting
menu. ( page 48)
Æ
(2) Input Selection Buttons: <COMPUTER 1>,
<COMPUTER 2>, <HDMI>, <VIDEO>,
<S-VIDEO>, <COMPONENT>.
These buttons are used to select the input signal.
( page 29)
Æ
(3) ▲▼◄► Buttons, <ENTER> Button
Navigate the MENU display.(
(4) <SCREEN> Button
Select a screen mode. (
(5) <MENU> Button
Open or close the On-Screen Menu. (
(6) <FREEZE> Button
Pauses the projected image and sound tentatively.
( page 30)
Æ
(7) <AV MUTE> Button
Temporarily turn off the image on the screen.
( page 31)
Æ
(8) <D.ZOOM +/- > Buttons
Zoom in and out the images. (
(10)
(11)
(12)
(13)
(14)
(15)
(16)
page 32)
Æ
page 44-46)
Æ
page 32)
Æ
page 31)
Æ
(9) <VOLUME +/- > Buttons
Adjusts the volume of the speaker. (
(10) < >Button
Turn the projector on or off. (
(11) <KEYSTONE> Button
Correct keystone distortion. (
(12) <INFO.> Button
Operate the information function. (
(13) <LAMP> Button
Select a lamp mode. (
Æ
(14) <P-TIMER> Button
Operate the P-timer function. (
(15) <IMAGE> Button
Select the image mode. (
(16) <MUTE> Button
Mute the sound. ( page 30)
Æ
(17) Remote control signal emitter
Attention
Do not drop the remote control.
z
Avoid contact with liquids.
z
Do not attempt to modify or disassemble the remote
z
control.
Note
The remote control can be used within a distance of
z
about 7 m (22.97 ft) if pointed directly at the remote
control signal receiver. The remote control can control at
angles of up to ± 30 ° vertically and ± 30 ° horizontally,
but the effective control range may be reduced.
If there are any obstacles between the remote control
z
and the remote control signal receiver, the remote control
may not operate correctly.
You can operate the projector by reflecting the remote
z
control signal on the screen. The operating range may
differ due to the loss of light caused by the properties of
the screen.
When the remote control signal receiver is lit with a
z
fluorescent light or other strong light source, the projector
may become inoperative. Set the projector as far from
the luminous source as possible.
page 31)
Æ
page 25)
Æ
page 30)
Æ
page 30)
Æ
page 31)
page 31)
Æ
page 30)
Æ
ENGLISH -
15