GE PV977 Owner’s Manual And Installation Instruction page 24

Troubleshooting tips ... Before you schedule service
Save time and money! Review the chart below first and you may not need to schedule service.
Problem
Fan turned on by itself
and is in MED setting.
The fan setting can be
adjusted but not to OFF
A collar around a
push button is not
illuminating when
pressed
Two or more collars
around the push
buttons are not
illuminating when
pressed
Sequential presses
of the LIGHT or FAN
buttons will change
the setting from lowest
setting to OFF, to
highest setting, to OFF,
to the lowest setting
24
Possible Cause
The heat sensor is activated
Push button may be stuck
Two or more push buttons may be stuck
This is normal. It is a feature of the hood
that the LIGHT and FAN buttons will
cycle around through the settings so that
you can easily set the controls to your
desired setting
What To Do
This is normal when temperatures below the hood are
exceeding the heat sensor limits. Remove the heat
source under the hood or wait until the hood cools to
appropriate levels. The hood will automatically turn
itself off or return to its original setting once the heat
sensor detects the temperature has reached a safe
condition
Check affected push button and ensure that it is not
stuck. Call for service if problem persists.
Check affected push button and ensure that it is not
stuck. Call for service if problem persists.
No action required
49-2000833 Rev. 0