Table of Contents
Advertisement
2.9 Adjusting the volume
2.9.1 Base unit
Important:
R Before adjusting the volume, set the operation
mode to fax mode. If the MFaxN light is OFF, turn
it ON by pressing MFaxN.
MFaxN
Ringer volume
While the unit is idle, press MCN or MDN.
To turn the ringer OFF
Press MCN repeatedly to display "RINGER OFF= OK?".
A MSetN
R The base unit will not ring for outside calls.
The base unit will ring at the low level for intercom
calls.
R To turn the ringer back ON, press MDN.
Handset receiver volume
While using the receiver, press MCN or MDN.
Monitor volume
While using the monitor, press MCN or MDN.
2.9.2 Cordless handset (KX-MB2060
optional)
MCNMDN
Ringer volume
1. MMENUN (soft key A) A M#NM1NM6NM0N
2. Press MCN or MDN to select the desired volume. A
MSAVEN (soft key A) A MOFFN
MSetN
MCNMDN
A
MOFFN
Note:
R When receiving a call, you can adjust the ringer
volume by pressing MCN or MDN.
R When the ringer volume is turned OFF,
displayed and the cordless handset does not ring for
outside calls.
However even when the ringer volume is set to OFF,
the cordless handset rings:
– at the low level for alarm (page 102) and intercom
calls (page 103)
– at the high level for paging (page 103)
Cordless handset receiver volume
While using the receiver, press MCN or MDN.
Speaker volume
While using the speakerphone, press MCN or MDN.
2. Preparation
is
27
Advertisement
Table of Contents
