Table of Contents
Advertisement
1. Introduction and Installation
1.9.1 Manual input tray
You can use the manual input tray for printing with the
computer and for copying. It can hold one page at a time.
When printing or copying multiple pages, add the next
page after the first page has been fed into the base unit.
R Please refer to page 137 for information on recording
paper.
R The unit is set for printing letter-size plain paper
by default.
– To use other paper sizes, change the
recording paper size setting (feature #381 on
page 81).
– To use thin paper, change the recording paper
type setting (feature #384 on page 81).
1
Adjust the width of the guides (A) to the size of the
recording paper.
2
Insert the paper, print-side down (B) until the base
unit grasps the paper and a single beep is heard.
Note:
R To print from the manual input tray;
– when printing with the computer, select #2 for the
printer properties.
– when making a copy, set the copy input tray
setting to "#2" beforehand (feature #460 on
page 90).
If these settings are not changed, when printing or
copying multiple pages, the 1st page will be printed
from the manual input tray, but the rest of the pages
will be printed from the paper input tray.
R If the paper is not inserted correctly, re-adjust the
paper, or the paper may jam.
18
B
A
1.10 Handset unit
Important:
R Before installing or removing the handset unit, be
sure to turn the power switch OFF.
1
Connect the handset cord (A).
2
Connect the handset connector (B).
R Remove the seal from the handset unit
connection jack if attached.
B
A
Advertisement
Table of Contents
