Lamp Replacement - Sanyo PLC-XT35 Owner's Manual

Lamp Replacement
When the projection lamp of the projector reaches its end
of life, the Lamp replacement icon appears on the screen
and LAMP REPLACE indicator lights yellow. Replace the
lamp with a new one promptly. The timing when the LAMP
REPLACE indicator should light is depending on the lamp
mode.
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
CAUTION
Allow a projector to cool for at least 45 minutes
before you open the Lamp cover. The inside of
the projector can become very hot.
Follow these steps to replace the lamp.
1
Turn off the projector and unplug the AC power cord.
Let the projector cool for at least 45 minutes.
2
Remove the screw that secures the lamp cover, and
then open the lamp cover.
3
Remove the two (2) screws that secure the lamp. Lift
the lamp out of the projector by using the handle.
4
Replace the lamp with a new one and secure the two
(2) screws. Make sure that the lamp is set properly.
Put the lamp cover back and secure it with the screw.
5
Connect the AC power cord to the projector and turn
on the projector.
6
Reset the lamp counter .
See "Resetting the Lamp Counter" on the next page.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering, give the following information to the dealer.
Model No . of your projector
●
Replacement Lamp Type No .
●
Maintenance and Filter Cleaning
Top Control
Lamp replacement icon
CAUTION
For continued safety, replace with a lamp of the same
type lamp. Do not drop the lamp or touch the glass
bulb! The glass can shatter and may cause injury.
Lamp cover
: PLC-XT35, PLC-XT35L, PLC-XT35K
: POA-LMP116
(Service Parts No. 610 335 8093)
LAMP REPLACE
indicator
Screw
Handle
Screws
59