Table of Contents
Advertisement
Mounting Guide
7.
Do one of the following:
−
Lift the locking plate, and install the tray assembly with standard disk drive into the
chassis, align the first slot on the mounting guide with the tab on the locking plate,
and lower the locking plate.
−
Slide the 5.25-inch device into the chassis, align the tab on the locking plate with the
first slot on the mounting guide, and lower the locking plate.
8.
Tighten the thumb screw on the top of the locking plate to lock the drive into place.
9.
Connect the proper interface cable (either SCSI or EIDE) and the power cable to the disk
drive.
Adding External SCSI Peripheral Devices
You can connect additional SCSI peripheral devices to the external port of the SCSI adapter,
which is located in the expansion slots on the back of the system. Note that adding an external
SCSI peripheral device may limit the speed of the SCSI bus channel to the speed of that
device.
Drive
37
Drive Tray
Access Hole (2)
Advertisement
Table of Contents
Need help?
Do you have a question about the RAX Systems and is the answer not in the manual?
Questions and answers