Table of Contents
Advertisement
36
2.
Loosen the thumb screw on the locking plate near the top left corner of the peripheral
device bay.
3.
Lift the locking plate.
4.
From inside the chassis, push the front of the tray and slide it out of the bay.
5.
If you are installing a SCSI device, do both of the following (see Chapter 5,
"Peripherals," for details):
−
Set the SCSI ID on the new drive to an unused ID number.
−
Disable termination on the new drive.
If you are installing an IDE device, proceed to the next step.
6.
Do one of the following:
−
If installing a standard disk drive, place the disk drive in the tray, align the mounting
holes, and install the four mounting screws. See the following figure.
−
If installing a 5.25-inch device, such as a tape drive or a CD writer, remove the right
and left mounting guides from the drive tray and attach the right mounting guide to
the right side of the device, and the left mounting guide to the left side of the device.
Locking Plate
Thumb Screw
Advertisement
Table of Contents
Need help?
Do you have a question about the RAX Systems and is the answer not in the manual?
Questions and answers