Installing The Blades; Final Connecting Rod Adjustments; Maintenance - Fanimation Punkah FP720 Series Owner's Manual

▲WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan.
NOTE: Blade(s) are not included and sold seperately.
Assembling the Fan Blades
1. Position the palm leaf, or the woven bamboo, or the
wicker blade over the blade holder with the threaded posts
showing. Make sure the bottom edge of the blade is fully
seated against the blade holder.
2. Place side "B" of the blade holder on top of the blade,
positioning the holes over the threaded posts.
3. With a Philips screwdriver, thread both screws into the
posts but do not fully tighten.
4. Prior to final tightening, position the centerline of the
blade with the center of the end of the blade holder.
5. Tighten both screws to secure the blade. Figure 16
1. Turn motor so that motor link is perpendicular to
connecting rod (see Motor Link Detail, Figure 17).
2. Loosen one of the outer set screws and adjust the
length of the connecting rod so that the fan blade is
centered on the blade holder.
3. Tighten the set screw.
4. Continue to the next connecting rod away from motor
and repeat the process for all connecting rods until all fan
blades are centered to the blade holder and parallel to
each other.
Periodic cleaning of your new fan is the only maintenance
that is needed. When cleaning, use only a soft brush or lint
free cloth to avoid scratching the finish.
Abrasive and/or non-abrasive cleaning agents are not
required and should be avoided to prevent damage to
finish.

Installing the Blades

Final Connecting Rod Adjustments

Maintenance

Motor Link Detail
CAUTION
Do not use water when cleaning your ceiling fan. It could
damage the motor or the finish and create the possibility
of electrical shock.
11
Figure 16
Blades
shown centered
and parallel
to each other
Figure 17