Operating Instructions - Cw110 Wall Control; Maintenance; Trouble Shooting - Fanimation Extraordinaire OF110 Series Owner's Manual

Operating Instructions - CW110 Wall Control

1. Restore electrical power to the outlet box by turning the
electricity on at the main fuse box.
2. NOTE: Set the rotary switch to High speed before using
the wall control.
The operating sequence is as follows:
• 4th Position = low speed
• 3rd Position = medium speed
• 2nd Position = high speed
• 1st Position = fan off
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed. When cleaning, use only a
soft brush or lint free cloth to avoid scratching the fi nish.
Abrasive and/or non-abrasive cleaning agents are not
required and should be avoided to prevent damage to
fi nish.
For your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan.
Trouble
1. FAN WILL NOT START
2. FAN SOUNDS NOISY
3. FAN WOBBLES
EXCESSIVELY

Maintenance

Trouble Shooting

▲WARNING
Probable Cause
1. Fuse or circuit breaker blown.
2. Loose power line connections to the fan, or loose
switch wire connections in the switch housing.
1. Motor noise caused by solid state variable speed
control.
1. Clevis nut in hanger bracket/downrod is loose.
2. Hanger bracket and/or ceiling outlet box is not
securely fastened.
CAUTION
Do not use water when cleaning your ceiling fan. It could
damage the motor or the finish and create the possibility
of electrical shock.
1. Check main and branch circuit fuses or circuit
breakers.
2. Check line wire connections to fan and switch wire
connections in the switch housings.
CAUTION: Make sure main power is turned off !
1. Some fan motors are sensitive to signals from
solid-state variable speed controls. Solid-state controls
are not recommended, choose an alternative control
method.
1. Tighten clevis nut securely in hanger bracket/
downrod support.
2. Tighten the hanger bracket screws to the outlet box,
and secure outlet box.
9
Figure 1
Suggested Remedy