Fanimation Extraordinaire OF110 Series Owner's Manual page 6

CAUTION
To Reduce the Risk of Personal Injury, this Product Must
be Secured as Described in the Manual.
1. Attaching Ceiling Support Cable (Figure 2): Drill ¼˝
pilot hole through one of the four corners of the junction
box, into the ceiling joist or structural member. Securely
attach the ceiling support cable with
fl at washer.
NOTE: Ceiling support cable must be directly secured to
ceiling joist or structural member between fl at washer and
junction box with 2˝ lag bolt (Figure 2).
2. Hanger Bracket Attachment (Figure 2): Drill ¼˝ pilot
hole through the center of the junction box, into the
ceiling joist or structural member. Attach hanger bracket
to the ceiling structure using
washer or to ceiling junction box acceptable for ceiling
support.
3. Assemble and secure the assembled fan with hex-
head bolt, two lockwashers, nylon locknut and clevis pin.
(Figure 3)
▲WARNING
It is critical that the clevis pin and lock nut in the hanger
bracket/downrod area is properly installed. Failure to
verify that the nut and hairpin clip are properly installed
could result in the fan falling.
INSTALLATION NOTE
The hanger bracket angle adjustment MUST ONLY be
used to orientate the downrod in a vertical downward
position.
4. (Optional) Sloped Ceiling Installation (Figure 4):
Loosen two nuts located on both sides of the hanger
bracket to orientate the downrod in the vertical position.
5. Make sure the electrical supply wires, including the
hanger bracket grounding wire and safety cable are
pulled through the downrod, between the hanger bracket
and the junction box so that electrical connections can be
made later.
6. Attach the safety cable to ceiling support cable. Slide
cable clamp onto safety cable (from fan). Place the end
of cable through the loop of ceiling support cable. Pull as
much cable through loop as possible. Feed end of cable
into clamp hole and fi rmly tighten screw (Figure 5). Cut
off excess safety cable.
▲WARNING
To avoid possible shock, do not pinch wires between the
downrod and the hanger bracket.
How to Hang Your Ceiling Fan (cont'd)
⁄ ˝ x 2˝ lag bolt and
3
8
⁄ ˝ x 5˝ lag bolt and fl at
3
8
Wood Member
(2" x 4" Approx.)
Ceiling
Ceiling
Support
Cable
Sloped
Ceiling
NOTE: Supply wires and
fan wires omitted for clarity
6
Ceiling Joist
Junction
Box
Hanger Bracket
Figure 2
Downrod
(Assembled Fan)
Figure 3
Loosen Nuts on
both sides of the
Hanger Bracket
Figure 4
Attach
Safety Cable
to Ceiling
Support
Cable
Figure 5