How To Wire Your Ceiling Fan; Installing The Canopy Housing - Fanimation TF9070TS Owner's Manual

Wet location ceiling fan

Hide thumbs

Table Of Contents

Table of Contents

If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a

licensed electrician.

▲WARNING

To avoid possible electrical shock, be sure electricity is

turned off at the main fuse box before wiring.

NOTE: If you are not sure if the outlet box is grounded,

contact a licensed electrician for advice, as it must be

grounded for safe operation.

1. Connect the green grounding lead from the hanger ball

and the green grounding lead from the hanger bracket to

the supply grounding conductor (this may be a bare wire

or wire with green colored insulation). Securely connect

wires with wire connectors supplied.

2. Securely connect the white fan motor wire to the white

supply (neutral) wire using wire connector supplied.

Securely connect the black fan motor wire and blue wire

to the black supply wire using wire connector supplied

(Figure 1). After connections have been made, turn leads

upward and carefully push leads into the outlet box, with

the white and green leads on one side of the outlet box

and the black and blue leads on the other side of the outlet

box.

3. Proceed to the next step of "Installing the Canopy

Housing".

NOTE: This step is applicable after the necessary wiring

is completed.

▲WARNING

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy housing

and not pinched between the housing and the ceiling.

1. Loosen the two shoulder screws in the Hanger

Bracket.

2. Securely attach the Canopy Housing over the shoulder

screws (Figure 1a).

3. Securely attach and tighten the Canopy Screw Cover

over the shoulder screws in the Hanger Bracket utilizing

the keyslot twist-lock feature (Figure 1b).