How To Assemble Your Ceiling Fan - Fanimation Edgewood TF100 Series Owner's Manual

Standard ceiling fan

Hide thumbs Also See for Edgewood TF100 Series:

Specification sheet (2 pages)

Table Of Contents

Table of Contents

1. Prior to assembly, set aside and save the hardware

bags packed in the packing.

2. Remove the Hanger Ball by loosening the setscrew

in the Hanger Ball until the ball falls freely down the

Downrod. (Figure 1) Remove the Pin from the Downrod,

then remove the Hanger Ball. Retain the Pin and Hanger

Ball for reinstallation in Step 7.

3. The fan comes with blue, black, and white 80˝ wires.

Separate and untwist the three wires. Route the wires

through the Downrod.

NOTE: You will be using either the 4½˝ downrod

supplied with your fan or an optional down rod purchased

separately.

4. Loosen the two setscrews in the Downrod Support.

Install Downrod into Coupler. Align the Clevis Pin holes

in the Downrod with the holes in the Downrod Support.

(Figure 2)

NOTE: The clevis pin and setscrews must be properly

installed as described earlier, or fan-wobble could result.

5. Install the Clevis Pin, Hairpin Clip and tighten Set

Screws. (Figure 2) The Clevis Pin and Hairpin Clip must

be properly installed to prevent the Set Screws from

working loose.

6. Route wires through Canopy Screw Cover and Canopy.

Position Canopy on fan shown with open side facing up.

(Figure 2)

7. Reinstall the Hanger Ball (Figure 2) on the Down rod

as follows. Route the three 80˝ wires through the Hanger

Ball. Position the Pin through the two holes in the Down

rod and align the Hanger Ball so the Pin is captured in the

groove in the top of the Hanger Ball. Pull the Hanger Ball

up tight against the pin. Securely tighten the setscrew

in the Hanger Ball. A loose setscrew could create fan

wobble.

▲WARNING

It is critical that the clevis screw in the downrod support

is properly installed and the setscrews and nuts are

securely tightened. Failure to verify that the clevis screw,

nuts, hairpin clip and setscrews are properly installed

could result in the fan falling.

8. The fan comes with blue, black, and white leads. Before

installing fan, measure up approximately 6-9 inches above

top of Downrod/Hanger Ball Assembly. Cut off excess wire

and strip back insulation ½˝ from each end of wires.

9. You have now completed the assembly of your new

ceiling fan. You can now proceed with the hanging and

the electrical wiring of your fan.