Door Alignment; Grille Fan Assembly; Defrost Control Assembly - LG LRMVS3006 Series Service Manual

Hide thumbs Also See for LRMVS3006 Series:
Table of Contents

Advertisement

3-4 Left Door Alignment
If the level of refrigerator doors is uneven, follow the
instructions below to align the doors:
Turn the leveling legs (CW) to raise or (CCW) to lower the
height of the front of the refrigerator by using flat blade
screw driver or 11/32" wrench. Use the wrench (Included
with the Owners Manual) to adjust the bolt in the door hinge
to adjust the height. (CW to raise or CCW to lower the
height.)
3-5 Right Door Alignment
The right refrigerator door does not have an adjustable nut.
If the space between the doors is uneven, follow
the instructions below to align the right door:
1 With one hand, lift up both the inner and outer door
sections of the right door to raise them at the middle hinge.
(It may be easier to lift it with the doors open.)
2 With the other hand, use pliers to insert the
snap ring on the middle hinge of the inner
door section as shown. Do not insert the ring
on the hinge of the outer door section.
3 Insert additional snap rings until the right
door is aligned. (Two snap rings are provided
with the unit.)
3-6 Grille Fan Assembly Replacement
1) Remove the plastic guide for slides on left side by
unscrewing phillips head screws.
2)
Pull out the cover grille to disassemble by using tools
shown in the figure.
3)
Put your hand into the inside of grille to disassemble
shown in the figure.
4)
Disconnect wire harness of the grille assembly.
5)
Replace the grille fan assembly.
(1)
(3)
(5)

3-7 DEFROST CONTROL ASSEMBLY

Defrost Control assembly consists of Defrost Sensor and
FUSE-M.
The Defrost Sensor works to defrost automatically. It is
attached to the metal side of the Evaporator and senses its
temperature. At 46F(8°C), it turns the Defrost heater off.
Fuse-M is a safety device for preventing over-heating of
the heater when defrosting.
1. Pull out the grille assembly. (Figure 1)
2. Separate the connector with the Defrost Control
assembly and replace the Defrost Control assembly after
cutting the Tie Wrap. (Figure 2)
GRILLE ASSEMBLY
-8-
(2)
(4)
DEFROST-CONTROL
ASSEMBLY
Copyright © 2019 LG Electronics Inc. All rights
reserved. Only training and service purposes.

Advertisement

Table of Contents
loading

Table of Contents