Disassembly; Removing And Replacing Refrigerator Doors - LG LRMVS3006 Series Service Manual

3. DISASSEMBLY

3-1 REMOVING AND REPLACING REFRIGERATOR DOORS

Removing Refrigerator Door
●
CAUTION: Before you begin, unplug the refrigerator. Remove food and bins from doors.
Left Door -FIG. 2
●
1. Disconnect water supply tube by pushing back on the disconnect ring.-FIG. 1
2. Open door. Loosen top hinge cover screw (1).
(If FIG.4 is engraved) Using a flat tip screwdriver, remove the left and right hooks as shown in the engraving.
3.
Use flat tip screwdriver to pry back hooks on front underside of cover (2). Lift up cover.
4. Disconnect door switch wire harness and remove the cover.
5. Pull out the tube.
6. Disconnect all wiring harnesses (4). Remove the grounding screw (5).
7. Rotate hinge lever (6) counterclockwise. Lift top hinge (7) free of hinge lever latch (8).
CAUTION: When lifting hinge free from the latch, be careful that door does not fall forward.
8. Lift door from middle hinge pin and remove door.
9. Place the door with the insides facing up, on a not scratch surface.
Right Door -FIG. 3
●
1. Open the door, Loosen top hinge cover screw (1). Lift up cover (2).
2. Disconnect all wiring wire harnesses (3)
3. Rotate hinge lever (4) clockwise. Lift top hinge (5) free of hinge lever latch (6).
4. Lift door from middle hinge pin and remove door.
CAUTION: When lifting hinge free from the latch, be careful that the door does not fall forward.
5. Place the door with the insides facing up, on a not scratch surface.
(1)
(2)
Figure 4 (Right)
Figure 4 (Left)
(2)
Figure 2
(6)
(7)
(8)
-5-
(4)
(5)
Figure 1
1) Insert the tube until you can see only one of
the lines printed on the tube.
2) After inserting, pull the tube to ascertain that
it is secure.
3) Assemble clip.
Correct
Figure 3
(4)
(5)
(3)
Incorrect
Copyright © 2019 LG Electronics Inc. All rights
reserved. Only training and service purposes.
(6)