Configuring The Ethernet Module - Extreme Networks PoS Installation And User Manual

config ppp ipcp off port 1:4
config ppp bcp off port 1:4
create vlan customerx
config vlan customerx add port 1:4
config ports 1:4 tunnel hdlc mpls
The following configuration commands apply to the PoS module installed in slot 8 of
BlackDiamond switch 2, as shown in Figure 3-20.
config ppp ipcp off port 8:4
config ppp bcp off port 8:4
create vlan customerx
config vlan customerx add port 8:4
config ports 8:4 tunnel hdlc mpls
The PoS port should be the only port in the VLAN.

Configuring the Ethernet Module

The following configuration commands apply to the Ethernet module installed in slot 8
of BlackDiamond switch 1, as shown in Figure 3-20.
create vlan mplsCloud
config vlan mplsCloud add port 8:1
config vlan mplsCloud ipaddress 10.1.1.1/24
enable ipforwarding mplsCloud
config ospf routerid automatic
config ospf add vlan mplsCloud area 0.0.0.0
enable ospf
The following configuration commands apply to the Ethernet/MPLS module installed
in slot 1 of BlackDiamond switch 2, as shown in Figure 3-20.
create vlan mplsCloud
config vlan mplsCloud add port 1:1
config vlan mplsCloud ipaddress 10.1.1.2/24
enable ipforwarding mplsCloud
config ospf routerid automatic
config ospf add vlan mplsCloud area 0.0.0.0
enable ospf
For more information about VLANs and OSPF features supported by
ExtremeWare, see the ExtremeWare Software User Guide.
Packet Over SONET Module Installation and User Guide
Configuring Port Tunneling
3-99