Installation and Setup
2
This chapter describes the following:
• How to decide where to install the Summit switch
• Gigabit Ethernet configuration rules
• How to install the switch in a rack or free-standing
• How to connect equipment to the console port
• How to check the installation using the Power On Self-Test (POST)
Caution: Use of controls or adjustments of performance or procedures other than
those specified herein may result in hazardous radiation exposure.
F
OLLOWING
Before installing or removing any components of the switch, or before carrying out any
maintenance procedures, you must read the safety information provided in Appendix A
of this guide.
D
ETERMINING THE
The Summit switch is suited for use in the office, where it can be free-standing or
mounted in a standard 19-inch equipment rack. Alternatively, the device can be
rack-mounted in a wiring closet or equipment room. Two mounting brackets are
supplied with the switch.
S
S
H
I
UMMIT
WITCH
ARDWARE
S
AFETY
S
G
NSTALLATION
UIDE
I
NFORMATION
L
WITCH
OCATION
2-1