Connecting Heater To Gas Supply - GHP Group TT1-15C User's Manual And Operating Instructions

Read and understand all safety information before connecting heater to propane tank.
1. (Applies to dual burner models only). Place heater onto tank with tank collar bracket over tank collar (Fig. 1)
Mounting bolt knob should be positioned to the outside of tank collar and be positioned as closely as possible
directly opposite to the cylinder valve outlet. See Figures 1 and 2.
2. (Applies to dual burner models only). Firmly secure to tank by hand-tightening mountingbolt knob.
Do not overtighten mounting bolt knob.
3. Make sure heater regulator knob is in the OFF
4. Insert regulator's connector into tank's valve outlet fitting and turn left (counterclock-wise) until fully tightened.
Threads are left-handed. (Figure 3.)
NOTE: Heater features a hand wheel that can be used to tighten the fitting to the cylinder. No
wrench required.
NOTE: The vertical stem of this heater must be installed in the vertical position. This heater is
equipped with a safety shutoff switch in the event that the heater is tipped over during operation.
The heater may fail to remain lit if the vertical stem is not installed vertically.
5. For single burner models loosen the wing bolt securing the support leg and position it firmly on
the surface of the cylinder. Tighten wing bolt firmly.
6. Open propane tank valve slowly by turning counterclockwise
7. Check all fittings for leaks. Apply a 50/50 mixture of liquid soap and water to all joints. Bubbles forming
show a leak. Correct all leaks at once.
WARNING: NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS.
8. Always remove propane tank from heater after each use. Do not store heater while attached
to propane tank.
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
PROPANE TANK TOP HEATER
CONNECTING HEATER TO PROPANE TANK
position.
.
8