Table of Contents
Advertisement
SERIES3800/S120T
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 and
JPL2 to enable or disable the LAN1 and
LAN2 Ethernets port, respectively. See
the table on the right for jumper set-
tings. The default setting is enabled.
2
I
C Bus to PCI-X/ Slots
2
Jumpers JI
C1 and JI
connect the System Management Bus
(I
2
C) to the PCI-X slots. The default
setting is Disabled. Both jumpers must
be set to the same setting See the table
on the right for jumper settings.
2
I
C Bus to PCI-Exp. Slots
2
Jumpers JI
C3 and JI
connect the System Management Bus
(I
2
C) to the PCI-E slots. The default
setting is Disabled. Both jumpers must
be set to the same setting See the table
on the right for jumper settings.
Watch Dog Enable/Disable
JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application hangs. Jumping pins 1-2
will cause WD to reset the system if an
application hangs. Jumping pins 2-3
will generate a non-maskable interrupt
signal for the application that hangs.
See the table on the right for jumper
settings. Watch Dog must also be en-
abled in BIOS.
Note: When enabled, the user needs to
write their own application software in
order to disable the Watch Dog Timer.
User's Manual
(7045A-C3/7045A-CT)
2
C2 allow you to
2
C4 allow you to
5-22
LAN1/2 Enable/Disable
Jumper Settings (JPL1)
Jumper Setting
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
I
2
C to PCI-X Slots
Jumper Settings (JI
2
C1/JI
Jumper Setting
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
I
2
C to PCI-E Slots
Jumper Settings (JI
2
C3/JI
Jumper Setting
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
Watch Dog
Jumper Settings (JWD)
Jumper Setting
Defi nition
Pins 1-2
Reset
Pins 2-3
NMI
Open
Disabled
2
C2)
2
C4)
Advertisement
Table of Contents
