Mitsubishi Electric Lossnay LGH-15RVX-ER Installation Instructions Manual page 10

Installation method (continued)
Connecting the power supply cable
1. Remove the black screws and the control box cover
LGH-15 to 100 RVX-ER
Control box cover
Black screws
LGH-150 and 200 RVX-ER
Control box cover
Black screws
2. Attach the screw cap.
Models LGH-15 to 100RVX-ER
Screw
Screw cap
CAUTION
caps to the screws at the bottom of the unit.
3. Connecting the power supply cable and
transmission cable
Pass the Power supply cable through the bush* and connect to the
TM1 terminal block using the round terminals. Connect the ground
wire to the ground terminal and secure tightening the bush. (* Use
Insert the cutting
PG connector
TM1
Ground wire Power supply cable
CAUTION
cable by 5 cm or more to prevent malfunctioning of the unit.
the conductors may touch and short out.
terminal block.
cover.
Models LGH-150 and 200RVX-ER
Screw
Screw cap
Bush
Cord clip
Transmission cable
Power supply cable
2 (ø9)or more.
be created. Connect the necessary parts.
1
2
external device including other manufactures.
3
4 By-pass monitor or Pre-heater signal output.
5 Malfunction monitor output.
6 Operation monitor output
7
To change fan speed by 0 - 10 VDC input
10
11
12
remote control
CAUTION
lamp, monitoring unit, etc.) using output signals of the
Lossnay unit, make sure to install safety equipment for the
external devices.
1
When connecting with remote controller (PZ-61DR-E)
according to .
11
Securely connect the transmission cable from the remote controller
to 1 and 2
2
Note
transmission cable.
Number of transmission cables which can be connected to
single input terminal is up to 4 wires.
Power supply
2
1
Up to two remote controllers
Transmission cables
Eng-9