Table 3-2 Cpu Matrix Display - Led Status Indications - Motorola IRRInet-XL Owner's Manual

Table 3-2 CPU Matrix Display - LED Status Indications

LED
Status
Symbol
CPU Flashing
M1 Flashing
M2 Flashing
M3 Flashing
LOAD On
CONF On
APPL On
Flashing
MON On
TX1 On
TX2 On
TX3 On
RX1 On
RX2 On
RX3 On
CM1 On
Indication
CPU is in Bootstrap Mode.
Failure in M1 module.
Failure in M2 module.
Failure in M3 module.
Configuration definition or application program is being
downloaded to Flash memory.
A Site Configuration definition has been loaded into the
Flash memory.
An Application Program has been loaded into Flash
memory.
Relates to one of the following:
– The program is in STOP SCAN state, for the Toolbox
Application Programmer's monitoring program to
perform diagnostic operations
– The application run-time is to long. Could be caused
by an error in the Ladder Diagram Program (i.e., infinite
loop).
– The Application Program is in STOP state. This
occurs when the Programming Toolbox's Hardware
Test & Calibration Program is performing a Hardware
Test.
The Monitoring Program of the Toolbox Application
Programmer is executing on-line monitoring of the RTU.
RTU transmits data via Port 1
RTU transmits data via Port 2
RTU is transmits data via Port 3
RTU receives data via Port 1
RTU receives data via Port 2
RTU is receives data via Port 3
Communication channel used by Port 1 is busy.
3-6