Homewerks 7130-13-BT Manual page 8

INSTALLATION INSTRUCTIONS (continued)
10. Remove the wiring box cover from the fan housing (A). Pull
the house wires through the hole in the wiring box cover. Using
the quick connectors, connect the house wiring to the LED
wall switch (E) and fan housing (A). 14 AWG is the smallest
conductor that should be used for branch circuit wiring. Please
refer to the wiring diagram on page 5 to ensure proper wire
connections are made. Carefully push the wire connections into
the wiring box and reattach the wiring box cover.
NOTE: When wiring the LED wall switch (E), do not use metal
wall plate as it may cause interference with the fan operation.
CAUTION: The switch included with this ventilation fan
requires a neutral wire connection. If a neutral line is not
present, one must be run by a qualified electrician. If
you require assistance, please call 1-877-319-3757 before
attempting switch installation.
CAUTION: This switch is intended to only operate with this
bath fan. Connections to other electrical fixtures are prohibited
and could cause electrical issues.
IMPORTANT: Do not turn on the power supply to the fan
until Step 13 or the LED wall switch will not pair to the fan or
function properly.
11. Connect a 4 in. circular duct to the fan housing (A), securing
it with duct tape or a clamp. Vent the duct to the outside.
12. Join the connectors for the BLUETOOTH
fan housing (A) to the grille (B).
IMPORTANT: The grille (B) must be connected BEFORE
turning on power to the fan.
13. Attach grille (B) by pinching the mounting springs and
inserting them into the narrow rectangular slots in the fan
housing (A).
Restore the power supply to the wall switch and fan by
turning on the circuit breaker or re-inserting the fuse. Turn on
the fan.Test the unit.
speaker from the
®
8
10
A
11
A
12
A
B
13
A
B
Wiring box cover
Quick connector
Wiring box cover
Mounting
springs
Housing
slots
Mounting
springs
Homewerks.com