Installation Instructions - Homewerks 7130-13-BT Manual

INSTALLATION INSTRUCTIONS

BEFORE INSTALLATION
WARNING: RISK OF ELECTRIC SHOCK! Ensure the electricity
to the wires you are working on is shut off. Either remove the
fuse or turn off the circuit breaker before removing the existing
bath fan or installing the new one.
1. Remove existing fan.
If you are not replacing an existing fan, skip to
step 4 or 7.
2. Measure the opening to ensure it is large enough to
accommodate the 9 in. x 9 in. dimensions of the new fan
housing (A).
3. If this fan is not replacing an old fan, be sure to cut a
9-1/4 in. x 9-1/4 in. opening for the fan housing (A).
For spacing of less than 21-1/4 inches between ceiling joists:
4. Place the fan housing (A) next to a ceiling joist. The fan
housing (A) should be level and perpendicular to the joist.
Allow for thickness of ceiling board used in your application.
Position the fan housing (A) so the bottom edge of the fan
housing (A) is flush with the ceiling board. Do not flush mount
the fan housing (A) to the bottom of the joist.
1
2
3
4
6
A
Homewerks.com