CEM ORACLE Operation Manual page 13

Power Conditioner
9. Unpack the power conditioner and place it on the work bench or the floor as far away from the ORACLE
magnet as possible.
Ensure that the power conditioner is not placed in close proximity with the ORACLE magnet to prevent
demagnetization of the magnet.
Note: CEM Corporation recommends that the ORACLE power cords be connected to electrical outlets and the power
switches remain in the "on" position at all times. After 10 minutes of idle time, the touchscreen assumes a "sleep"
mode.
Note: The power cord below is applicable to the U.S. only. Power cords for instruments installed in other countries will
be supplied based on electrical specifications for the applicable country.
Balance (if applicable)
10. Remove the plastic cover from the balance.
11. Place the balance on the workbench between the processor box (if applicable) and the power
conditioner.
12. Plug the power cord from the balance into one of the receptacles of the power conditioner.
CAUTION
ON
OFF
9