Electromagnetic Compatibility Information - Salter BPA-9200 Instructions And Guarantee

ELECTROMAGNETIC COMPATIBILITY INFORMATION

Table 1 For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacture's declaration – electromagnetic emission
The [BPA-9200] is intended for use in the electromagnetic environment specified below.
The customer or the user of the [BPA-9200] should assure that it is used in such an environment.
Emission test
RF emissions
CISPR 11
RF emission
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Table 2 For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer's declaration - electromagnetic immunity
The [BPA-9200] is intended for use in the electromagnetic environment specified below.
The customer or the user of the [BPA-9200] should assure that it is used in such an environment.
Immunity test
Electrostatic ±6 kV contact
discharge (ESD) ±8 kV air
IEC 61000-4-2
Power frequency 3A/m
(50/60 Hz)
magnetic field
IEC 61000-4-8
Compliance
The [BPA-9200] uses RF energy only for its internal function.
Group 1 Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
Class B
The [BPA-9200] is suitable for use in all establishments other
Not applicable than domestic and those directly connected to the public
low-voltage power supply network that supplies buildings used
for domestic purposes.
Not applicable
IEC 60601 test level Compliance level
±6 kV contact
±8 kV air
3A/m
13
Electromagnetic environment - guidance
Electromagnetic
environment - guidance
Floors should be wood, concrete or
ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30%.
Power frequency magnetic
fields should be at levels
characteristic of a typical location
in a typical commercial or hospital
environment
GB