Setup And Operating Procedures - Salter BPA-9200 Instructions And Guarantee

—Consult the dealer or an experienced radio/TV technician for help.
GB
17. This blood pressure monitor is verified by auscultatory method. It is recommended that you check annex B of ANSI/AAMI
SP-10:2002+A1:2003+A2:2006 for details of verification method if you need.

SETUP AND OPERATING PROCEDURES

1. BATTERY LOADING
a. Open battery cover at the back of the monitor.
b. Load four "AA" size batteries. Please pay attention to polarity.
c. Close the battery cover.
When LCD shows battery symbol
Rechargeable batteries are not suitable for this monitor.
Remove the batteries if the monitor will not be used for a month or more to avoid relevant damage of battery leakage.
Avoid the battery fluid to get in your eyes. If it should get in your eyes, immediately rinse with plenty of clean water and
contact a physician.
The monitor, the batteries and the cuff, must be disposed of according to local regulations at the end of their usage.
2. CLOCK AND DATE ADJUSTMENT
a. Once you install the battery or turn off the monitor, it will enter Clock Mode, and LCD will display time and date by turns.
See picture 2 & 2-1.
Picture 2
b. While the monitor is in Clock Mode, pressing both the "START" and "MEM" button simultaneously, a beep is heard and the
month will blink at first. See picture 2-2. Press the button "START" repeatedly, the day, hour and minute will blink in turn.
While the number is blinking, press the button "MEM" to increase the number. Keep on pressing the button "MEM", the
number will increase fast.
c. You can turn off the monitor by pressing "START" button when the minute is blinking, then the time and date is confirmed.
d. The monitor will turn off automatically after 1 minute of no operation, with the time and date unchanged.
e. Once you change the batteries, you should readjust the time and date.
3. CONNECTING THE CUFF TO THE MONITOR
Insert the cuff tubing connector into the socket in the left side of the monitor. Make certain that the connector is completely
inserted to avoid air leakage during blood pressure measurements.
Avoid compression or restriction of the connection tubing during measurement, which may cause inflation error, or
harmful injury due to continuous cuff pressure.
, replace all batteries with new ones.
Picture 2-1
6
Picture 2-2