Displaying Stored Results - Salter BPA-9200 Instructions And Guarantee

d. The monitor inflates the cuff until sufficient pressure has built up for a measurement. Then the monitor slowly releases
GB
air from the cuff and carries out the measurement. Finally the blood pressure and pulse rate will be calculated and
displayed on the LCD screen separately. Irregular heartbeat symbol (if any) will blink. See picture 6-4 & 6-5. The result
will be automatically stored in the current memory bank.
Picture 6-3
e. After measurement, the monitor will turn off automatically after 1 minute of no operation. Alternatively, you can press
the "START" button to turn off the monitor manually.
f. During measurement, you can press the "START" button to turn off the monitor manually.
Note: Please consult a health care professional for interpretation of pressure measurements.

7. DISPLAYING STORED RESULTS

a. After the measurement, you can review the measurements in the current memory bank by pressing button "MEM". Now
the LCD displays the amount of the results in the current bank. See picture 7.
Picture 7
b. Alternatively, press "MEM" button in Clock Mode to display the stored results. The current memory bank will blink and
the amount of results in this bank will be displayed. See picture 7-1. Press "START" button to change over to other bank.
See picture 7-2. Confirm your selection by pressing "MEM" button. The current bank can also be confirmed automatically
after 5 seconds with no operation.
c. After selecting the memory bank, the LCD will display the average value of the last three results in this bank, See picture
7-3 &7-4. If no result stored, LCD will show dashes as picture 7-5.
Picture 7-3
Picture 6-4
Picture 7-1
Picture 7-4
8
Picture 6-5
Picture 7-2
Picture 7-5