Electromagnetic Compatibility Information - Salter BPW-9100 Instructions And Guarantee

ELECTROMAGNETIC COMPATIBILITY INFORMATION

GB
Table 1 For all ME EQUIPMENT and ME SYSTEMS
The [BPW-9100] is intended for use in the electromagnetic environment specified below.
The customer or the user of the [BPW-9100] should assure that it is used in such an environment.
Emission test
RF emissions
CISPR 11
RF emission
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Table 2 For all ME EQUIPMENT and ME SYSTEMS
The [BPW-9100] is intended for use in the electromagnetic environment specified below.
The customer or the user of the [BPW-9100] should assure that it is used in such an environment.
Immunity test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
Guidance and manufacture's declaration – electromagnetic emission
Compliance
Group 1
Class B
Not applicable
Not applicable
Guidance and manufacturer's declaration - electromagnetic immunity
IEC 60601 test level
±6 kV contact
±8 kV air
3A/m
Electromagnetic environment - guidance
The [BPW-9100] uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
The [BPW-9100] is suitable for use in all establishments other
than domestic and those directly connected to the public
low-voltage power supply network that supplies buildings used
for domestic purposes.
Compliance level
±6 kV contact Floors should be wood, concrete or
±8 kV air ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30%.
3A/m Power frequency magnetic
fields should be at levels
characteristic of a typical location
in a typical commercial or hospital
environment
12
Electromagnetic
environment - guidance