Table of Contents
Advertisement
7. First lift carefully and then remove the glass
panel.
1
8. Clean the glass panel with water and soap.
Dry the glass panel carefully.
When the cleaning is completed, install the
glass panel and the oven door. Do the above
steps in the opposite sequence.
The screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel frame
on the screen-printing zones is not rough when
you touch it.
Make sure that you install the internal glass
panel in the seats correctly.
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
16
90°
2
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Remedy
www.zanussi.com
Advertisement
Table of Contents
