Requirements For Installation Location - OSO HOTWATER Wally Series Installation Manual

3.3.2 Wall bracket
The product can be mounted on the floor or wall
and is supplied with a wall bracket (7) from the fac-
tory. Original wall brackets must be used for instal-
lation. Check that the floor or wall will withstand the
full weight of the product in operation. The mini-
mum distance from ceiling to wall bracket is 25 cm.,
see section 3.4 and illustration below.
Wooden wall: Bracket should preferably be fixed
with four screws to wall beams, at least two verti-
cally above each other in studs/beams. Use 8 mm.
French wood screws. For other types of wall, suitable
fastening materials must be selected for any given
wall design.
Installation of heater on bracket:
The product should be tilted down slightly on the
bracket before turning it against the wall, see illus-
tration. Make sure that the product is lowered all the
way down to the bracket and that the back of the
product is in full contact with both bracket and wall.
3.4 Requirements for installation location and
positioning
The product should be placed in a room with a drain, in accordance with local rules. Alter-
!
natively, fit an automatic stop valve with sensor and overflow from safety valve to drain.
!
The product should be placed in a dry and permanently frost-free position.
The product should be fixed to a wall structure suitable for the total weight of the product
!
when in operation.
The minimum distance from the ceiling to the centre of the upper screw hole on the wall
!
bracket is 25 cm. because of the space needed for hanging. See diagram below.
The product must have a clearance for servicing of 40 cm in front of the cover / 10 cm under
!
the base plate where it is wall-mounted.
!
The product should be easily accessible in the home for servicing and maintenance.
Min.
40 cm
7
! CAUTION
Min.
25 cm
Min. 40 cm
Min. 10 cm for wall mounting
7
7