Installing An Rru Rf Jumper - Huawei RRU3971 Installation Manual

Figure 8-15 Correct position of an OT terminal
Step 3 Label the installed cable according to the instructions in Attaching a Cable-Tying Label.
----End

8.6 Installing an RRU RF Jumper

This section describes the procedure for installing an RRU RF jumper.
Procedure
Step 1 Connect the 4.3-10 straight male connector on the RRU RF jumper to the antenna port, and use
a torque wrench to tighten the connector to 5 N·m (44.25 lbf·in.), as shown in
Figure 8-16 Installing an RRU RF jumper
Issue () Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Installing RRU Cables
Figure 8-16.
101