Taking Pictures From Your Computer - Epson PhotoPC PhotoPC User Manual

Follow these steps to set the port and speed for your PhotoPC
connection:
1
Connect the camera to your computer and open the Setup screen as
described on page 5-1. The Computer Connection box shows the
current port settings.
2
Click the arrow to change the Port setting. You can select from
COM1, COM2, COM3, or COM4.
NOTE
Do not change the Port setting unless you want to use a different
port or you get an error message. When you change the Port
setting, you lose the connection between the camera and your
computer.
In most cases, you should select either COM1 or COM2,
depending on which serial port you connected the camera to.
If you have a serial device connected to one port and an internal
modem on the other, you can try COM3 or COM4. You may have
to reconfigure your ports in the Windows Control Panel. If you get
an error message, see page 6-3 for more information.
3
Click the arrow to change the Speed setting.
EasyPhoto automatically chooses 38,400 baud, a speed that works
with most computers. You can experiment to choose the fastest
speed that works on your system. Increasing your port speed will
make pictures transfer much faster from the camera to your
computer.
4
When you are finished, click OK.

Taking Pictures from Your Computer

When the camera is connected to your computer, you can take pictures
and use PhotoPC features through the software on your computer. The
only control you can use on the camera itself is the power switch.
5-5
Using Advanced Features
5
A