Table of Contents
Advertisement
The camera has no power.
Check the power switch and make sure the camera is turned on.
The camera may have shut off automatically. Slide the power
switch off and then on.
Check the batteries and make sure they are installed correctly.
Replace the batteries if necessary, following the instructions on
page 1-2.
If you are using the AC adapter, make sure it is plugged into a
working outlet.
You can't take a picture with the camera.
The flash may be recharging. Wait until you see the green standby
light, and try again.
The camera may be full. Check the picture counter on the control
panel. Erase a picture using the erase button, or transfer the pictures
to your computer and then erase them. See Chapter 3 for
information about transferring your pictures and erasing them with
your computer.
The camera may be connected to your computer. When it's
connected, you can't use any of the controls on the camera itself.
See page 5-5 for instructions on taking pictures from your
computer.
6-2
Maintenance and Troubleshooting
The flash doesn't work.
Make sure the flash setting is either automatic or forced flash.
Check the batteries and make sure they are installed correctly.
Replace the batteries if necessary, following the instructions on
page 1-2.
You get an error message when you try to transfer your pictures from
the camera to your computer.
Make sure the cable is connected correctly, as described on page
3-1.
Make sure the camera is turned on and the batteries have enough
power.
Check the serial port settings in your PhotoPC software. You may
need to change the settings for the Port and Speed of your serial
connection.
If you have an internal modem on one port and a serial device
connected to the other port, you may not be able to use COM1 or
COM2. You can select COM3 or COM4. However, you may need
to reconfigure your ports in order to use these settings.
Advertisement
Table of Contents
