Canon TX-4100 Online Manual page 255

◦ ◦ Disable
Switches the roll paper for printing by estimating the remaining amount based on the roll amount
value you entered.
In addition, if the roll length is not specified properly, paper may remain when switching, or it may
have run out while printing is in progress.
• • Roll paper auto switching
Enables/Disables switching roll paper feed position by detecting the paper size.
• Detect paper setting mismatch •
Selects printer action when you start printing with the paper size, the media type, and print settings
different from those registered.
• Paper retention settings •
Selects whether to contact the roll nip with the rolls in feeding paper.
◦ ◦ If you select While feeding, the roll nip contacts with the rolls and automatic feeding is enabled.
◦ ◦ If you select Release, the roll nip does not contact with the rolls.
If you select Release, automatic feed and automatic switching of top and bottom roll paper can not
be performed. Feed paper manually.
• • Advanced paper settings
Performs advanced paper settings for each media types.
• Paper size recognition settings •
Selects which size is preferred when paper size detection is enabled.
◦ ◦ Cut sheet setting 1
Select whether ISO A3+ or 13"x19"(Super B) is applied when a sheet of an intermediate size is
detected.
◦ Cut sheet setting 2*1 ◦
Select whether ISO B1 or 28"x40" (ANSI F) is applied when a sheet of an intermediate size is
detected.
*1: Not displayed on TX-2100 and TX-5210.
◦ Roll paper setting 1 ◦
Select whether A3 or 300 mm is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 2 ◦
Select whether B4 or 10 in. is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 3 ◦
Select whether 300 mm or 12 in. is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 4 ◦
Select whether 500 mm or 20"x24" is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 5 ◦
255