Before The Installation; Built-In Hobs; Connection Cable - Zanussi ZEV6340NBA User Manual

Problem
The hob deactivates.
Residual heat indicator does
not come on.
The sensor fields become hot.
comes on.
comes on.
and a number come on.
E6 comes on.
IF YOU CANNOT FIND A SOLUTION...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre. Give the data from the rating plate. Give
also three digit letter code for the glass ceramic (it
is in the corner of the glass surface) and an error
message that comes on. Make sure, you operated
INSTALLATION
WARNING! Refer to Safety chapters.

BEFORE THE INSTALLATION

Before you install the hob, write down the
information bellow from the rating plate. The rating
plate is on the bottom of the hob.
Serial number ...........................
Possible cause
You put something on the sen-
sor field .
The zone is not hot because it
operated only for a short time.
The cookware is too large or
you put it too near to the con-
trols.
Automatic Switch Off oper-
ates.
The Child Safety Device func-
tion operates.
There is an error in the hob.
The second phase of the pow-
er supply is missing.
the hob correctly. If not the servicing by a service
technician or dealer will not be free of charge, also
during the warranty period. The instructions about
the Service Centre and conditions of guarantee are
in the guarantee booklet.

BUILT-IN HOBS

Only use the built-in hobs after you assemble the
hob into correct built-in units and work surfaces
that align to the standards.

CONNECTION CABLE

• The hob is supplied with a connection cable.
• To replace the damaged mains cable use the
following (or higher) mains cable type:
H05V2V2-F T min 90°C. Speak to your local
Service Centre.
Remedy
Remove the object from the
sensor field.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Put large cookware on the rear
zones if possible.
Deactivate the hob and acti-
vate it again.
Refer to "Daily use" chapter.
Disconnect the hob from the
electrical supply for some time.
Disconnect the fuse from the
electrical system of the house.
Connect it again. If
on again, speak to an Author-
ised Service Centre.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse, wait
one minute, and insert the fuse
again.
comes
21