Set Up A Vpn Connection - TP-Link TL-MR150 User Manual

Chapter 12
• Network Destination
static route. This IP address cannot be on the same subnet with the WAN IP or
LAN IP of the router. In the example, the IP address of the company network is the
destination IP address, so here enters 172.30.30.1.
• Subnet Mask - Determines the destination network with the destination IP address.
If the destination is a single IP address, enter 255.255.255.255; otherwise, enter
the subnet mask of the corresponding network IP. In the example, the destination
network is a single IP, so here enters 255.255.255.255.
• Gateway - The IP address of the gateway device to which the data packets will
be sent. This IP address must be on the same subnet with the router's IP which
sends out the data. In the example, the data packets will be sent to the LAN port of
Router 2 and then to the Server, so the gateway should be 192.168.1.2
• Interface - Determined by the port that sends out the data packets. In the example,
the data is sent to the gateway through the LAN port.
5. Select the checkbox to enable this entry.
6. Click Save to save the settings.
Done!
Open a web browser on your PC. Enter the company server's IP address to visit the
company network.

12. 9. Set up a VPN Connection

VPN (Virtual Private Network) is a private network established across the public network,
generally via the internet. However, the private network is a logical network without any
physical network lines, so it is called Virtual Private Network.
- The destination IP address that you want to assign to a
Specify Your Network Settings
68