Disabled Outputs; Alarm Condition - Haes ELAN HS-5000 Series User Manual

Press the  button to show further information on the state, type, analogue/digital values, the
detection loop (LP) and address (ADRS), etc.
Press the 'ESC' key to return.
3.4.2

Disabled Outputs

The display presents a list of all of the zones in a disabled condition with the first disablement
highlighted. For example:
[ 2 Zone(s)with Outputs Disabled]
Zone Mode
0001 ALL DISABLED BASEMENT WEST
0100 ALL DISABLED RECEPTION
Press the  buttons to highlight the required zone and then press the  button to view the
individual outputs and their disablement condition. For example:
[ Outputs in Zone 0100]
Mode Device Text
Disabled Sounder A
Disabled Sounder B
Disabled Sounder C
Disabled Sounder D
The above example shows that the panel sounder circuits are disabled.
Press the  button to view further information including type, value and state, etc.
[ Outputs in Zone 0100]
<More>
Mode
Disabled
Disabled
Disabled
Disabled
Press the  buttons to scroll through the list of individual outputs within the selected zone. Press
the 'Esc' button to return to previous views and the main display.
3.5

Alarm Condition

When the system registers a pre-alarm or plant alarm condition, the internal buzzer sounds
intermittently and the display shows the cause of the fault in more detail. An example of the display
is shown below:
ZONE 0001
BASEMENT WEST
RESTAURANT
1 Zone In Alarm
To obtain more detailed information about the alarms, press the  button. The display then
presents a list of all zones in an alarm condition.
More>
Location
More>
Type
SOUNDER
SOUNDER
SOUNDER
SOUNDER
PRE-ALARM
(MULTI.SENSOR)
More>
< Zones with location text where
< outputs are disabled
< Location Text for First Zone
< Location Text and Type of Device
< No. of Zones in Alarm
Page 17 of 42