Epson PowerLite Pro Z8000WUNL User Manual page 42

Correcting Distortion in the Projected Image
E
Repeat steps 3 and 4 as needed to adjust any remaining
corners.
F
When you are done, press the [Esc] button to exit the
correction menu.
Because the correction method was changed to Quick Corner from
Keystone in the configuration menu, when [w/
[</ ], and [>/ ] buttons are pressed later, the screen for select-
ing the corner in procedure 2 is displayed. Change Keystone from
the configuration menu to H/V-Keystone if you want to correct
H/V-Keystone when pressing the [w/
[>/ ] buttons on the control panel.
If the Esc button is held down for about two seconds while correcting
with Quick Corner, the following screen is displayed.
Reset Quick Corner: Resets the result of Quick Corner corrections.
Switch to H/V-Keystone: Switches the correction method to
H/V-Keystone.
], [v/ ],
], [v/ ], [</ ], and
42