Epson PowerLite Pro Z8000WUNL User Manual page 166

General Notes
• Do not carry the projector by yourself. Two people should use the
handles to carry the projector when unpacking or moving it.
• Do not place the projector on an unstable cart, stand, or table. When
projecting images vertically, install the projector correctly and
appropriately to prevent it from turning over and falling.
• Do not operate the projector on its side, while tilted to one side, or
upside down. Do not tilt the projector forward or back at a greater
angle than that specified for vertical keystone correction. s
• If the projector is mounted on a ceiling, it should be installed by
qualified technicians using mounting hardware designed for use with
this projector. Also, when mounting the projector on the ceiling, make
sure to pass a wire through the handles to prevent it from falling.
• If you use a ceiling mount and apply adhesives to the mount to prevent
the screws from loosening, or if you use lubricants or oils on the
projector, the projector case may crack and the projector may fall from
its ceiling mount. This could cause serious injury to anyone under the
mount and could damage the projector. When installing or adjusting a
ceiling mount, do not use adhesives to prevent the screws from
loosening and do not use oils or lubricants.
• Do not stand on the projector or place heavy objects on it.
• Do not use the projector where it may be exposed to rain, water, or
excessive humidity.
• Unplug the projector from the wall outlet before cleaning. Use a dry
cloth (or, for stubborn dirt or stains, a moist cloth that has been wrung
dry) for cleaning. Do not use liquid, aerosol cleaners, or solvents such
as alcohol, thinner or benzine.
• Do not use any spray containing a flammable gas to remove dirt or dust
that is adhering to parts such as the lens or filter of the projector.
• Never spill liquid of any kind into the projector.
• Do not use the projector where it may be exposed to excessive dust or
smoke.
• Do not use the projector where it may be exposed to flammable,
corrosive, or explosive gases. Because the lamp inside the projector
becomes very hot during use, the gases may ignite and result in a fire.
• Never push objects of any kind through the cabinet slots or openings.
• Do not use or store the projector or remote control in a hot location,
such as near a heater, in direct sunlight, or in a closed vehicle.
• Incorrect battery usage may cause leakage of battery fluid and battery
p.159
rupture, which could result in fire, injury or corrosion of the projector.
When replacing batteries, take the following precautions: Insert
batteries so that the polarities (+ and -) are correct, do not use batteries
of different types, do not mix old and new batteries, and do not use any
batteries other than those specified in this User's Guide. Replace the
batteries as soon as they run out and remove the batteries if you will not
be using the projector for a long period of time. Do not expose batteries
to heat or flame and do not put them in water. Dispose of used batteries
according to local regulations. Keep these batteries out of the reach of
children. Batteries are choking hazards and are very dangerous if
swallowed. If the batteries leak, wipe away battery fluid with a soft
cloth. If battery fluid gets on your hands, wash them immediately.
• Do not use or store the projector in places where high and low
temperature extremes occur, or where the temperature can change
suddenly.
• Do not set up the projector in places where it might be subjected to
vibration or shock.
• Do not set up the projector near high-voltage electrical wires or sources
of magnetic fields.
• Do not store the projector standing on its side.
• Do not block the slots and openings in the projector case. They provide
ventilation and prevent the projector from overheating. If you are
setting up the projector near a wall, leave at least 19.7 inches (50 cm) of
space between the wall and the air exhaust vent.
166