Table of Contents
Advertisement
Quick Links
Assembly INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
!
Do not discard any of the packaging until you have checked that you have all the parts
and pack of fittings.
!
Keep children away during assembly. This item contains small parts which can be
swallowed by children. Children should always be under direct adult supervision while
using the product.
!
Retain the assembly instructions for future reference.
!
Please quote following FQC NO. when contacting service center.
INTENDED FOR RESIDENTIAL USE ONLY.
RUS422W
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
DON'T RETURN TO STORE!
STOP
PAGE 1 OF 6
-WM
COURTYARD CREATIONS INC.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Courtyard Creations RUS422W-WM
Summary of Contents for Courtyard Creations RUS422W-WM
- Page 1 Retain the assembly instructions for future reference. Please quote following FQC NO. when contacting service center. SERVICE CENTER TOLL FREE NO. TEL: 1-877-539-7436 FAX: 1-877-539-7439 DON’T RETURN TO STORE! STOP COURTYARD CREATIONS INC. PAGE 1 OF 6...
- Page 2 A. Please read instructions thoroughly. Acquaint yourself with the inventory of parts and the accompanying drawings to ensure safe and proper assembly. B. You will need the following tools - Phillips Screwdriver(Not Included) - Nut Wrench (See Part #29) - Hex. Key Wrench (See Part #28) C.
- Page 3 Do not tighten bolts/nuts ASSEMBLY (Note: For all nuts and bolts after Step 1. Fasten all fastening, always use a washer (#20 or #21) bolts/nuts after Fig A. between the tube and bolt or the tube and nut.) Step A - 1 and Step A - 2: Insert the top cross beam w/adjustable teeth (#1) into the upright supports (#2 and #3).
- Page 4 Step B : Fig. B Open the seat assembly (#7) and fasten a swing arm tube (#8) and a swing arm (#6) to the seat back by using bolt (#17), washers (#20), and plastic nut (#22). Do the same procedure for both sides. Fasten another swing arm tube (#8) to the swing arm (#6) at the front bend by using bolt (#18), washers (#20), and plastic nut...
- Page 5 Fig. E Step E - 1 & Step E - 2 : Slide the canopy/frame connectors (#26) into the side canopy braces (#9). Fasten them Step E - 1 together by using screws (#19) in the pre-drilled holes. Ensure that the teeth on the canopy/frame connectors are facing toward the inside of the frame.
- Page 6 Fig. G Step G : Place the cushions (#31) onto the seat assembly (#7). Secure the cushions to the seat assembly by using ties. To assure stability, double check that all of the bolts have been completely tightened, and then cover them with bolt caps (#24 and #25).
Need help?
Do you have a question about the RUS422W-WM and is the answer not in the manual?
Questions and answers